Old school Easter eggs.

Gas Chainsaws

Set the chainsaw on flat, stable ground with the bar pointing away from any obstacles. Make sure no people or pets are close by.
Be sure the chainsaw has enough fuel, the chain is at the appropriate tension, and the tool is in good working condition.

Use your right foot to press down on the trunk handle therefore the chainsaw is held steady.
Engage the chain brake.
Turn the chainsaw on, and open the choke fully. If your model of chainsaw includes a fuel primer, press it several times.
With your right foot still holding the chainsaw down, use your dominant hand to pull the start cord with a smooth, firm motion. Your other hand ought to be holding the chainsaw handle.
After the chainsaw engine begins to catch, close the choke halfway.
Pull the start cord again. You may want to do this a few times prior to the engine fully starts.
Adjust the choke to the run position. https://thefrisky.com/the-best-chainsaws-for-heavy-duty-cutting/ Allow chainsaw idle for some minutes until the engine is warm.
Lift the chainsaw up, release the chain brake, and you are ready to work.
Back to posts
This post has no comments - be the first one!

UNDER MAINTENANCE